News and Articles
19/10/2016 | News, February 2017
Solar district heating: Good performances all over Europe
The 4th International Solar District Heating (SDH) Conference, which had been organised under the auspices of Horizon 2020 project SDHp2m…from policy to market on 21/22 September 2016 in Denmark, showed the importance of analysing real-life monitoring data from European SDH plants, with one conference session dedicated exclusively to the topic.

These kinds of comparisons enable an understanding of the actual performance of such large collector fields and offer an opportunity for optimising power output and for creating best-practice examples of new plants. For example, the chart displays ten years’ worth of monitoring data from the German plant in Crailsheim, which has met solar yield expectations.


source: SDH conference presentation from ITW

Roman Marx from the German Institute of Thermodynamics and Thermal Engineering (ITW) of the University of Stuttgart, said that the average annual solar yield was 2,631 MWh (360 kWh/m2* a), compared to a previous estimate of 2,575 MWh. The solar fraction, however, reached a share of slightly above 40 %, below the expected 50 %. The reason for this lower-than-expected value was a higher total heat demand in the initial estimate, but also a lower usable capacity for seasonal storage, with the maximum storage temperature having been reduced from 80 to 70 °C. The owner of the plant is now considering a partial replacement of the 12-year old solar collectors by more efficient panels.


Monitoring data for the specific yield of 13 Austrian large-scale solar plants depending on feed and return line temperatures
source: SDH conference presentation from AEE Intec

The district heating session also included a report by Samuel Knabl from Austrian research institute AEE INTEC on the monitoring results of 30 of the country’s SDH plants, which had been supported by the national subsidy scheme for large-scale systems. The majority of the 14 systems which completed the monitoring phase almost achieved their expected solar yields; only two installations deviated significantly in their results. Knabl emphasised the fact that the return temperature of the district heating grid had a significant impact on collector field efficiency, as the above chart shows: specific collector yields ranged from 240 to 520 kWh/m2a.

Promising results came in from the biomass-fired district heating plant in Mallnitz, where in summer the peak load operation hours of the oil-fired boiler as well as the operation time of the biomass boilers was significantly reduced. Another example is the suburb of Salzburg-Lehen, where a 2,048 m2 collector field heats around 38,000 m2 of floor area in flats, a youth hostel, office buildings, a hotel and 150 renovated homes. The solar fraction is 29 %, of which 12 % are directly used in the buildings and 17 % originate from indirect use by the heat pumps, which have a seasonal performance factor of 4.5.

Plant

Marstal

Dronninglund

Braedstrup

Collector field

33 000 m2

37 600 m2

18 600 m2

Seasonal storage

75 000 m3 PTES

60 000 m3 PTES

19 000 m3 BTES

Short-term storage

2 100 m3

--

7 500 m3

Heat demand

32 000 MWh/a

40 000 MWh/a

45 000 MWh/a

Solar fraction

41 %

41 %

23 %

Specific yield of solar field

395 kWh/m2a

447 kWh/m2a

432 kWh/m2a

Seasonal storage efficiency

62 % (20 to 84 °C)

90 % (10 to 89 °C)

102 % (11 to 49 °C)*

Storage heat capacity (temperature difference)

5460 MWh (64 K)

5,500 MWh (64 K)

400 MWh (38 K)

No. of storage cycles

1

2.2

0.5


Primary technical and performance figures based on 2015 data from three Danish large-scale SDH plants. *102 % of storage efficiency has only been possible because the system used a certain amount of heat from the previous year. BTES is short for Borehole Thermal Energy Storage; PTES is Pit Thermal Energy Storage
Source: SDH conference presentation from Solites

The presentation by Thomas Schmidt from German research institute Solites confirmed the often-quoted average annual yield of 400 to 450 kWh/m2 for large-scale collector fields in Denmark. Schmidt went through the monitoring data provided by the operators of the three SDH systems in Marstal, Dronninglund and Braedstrup (see the table above). The difference in yield (between 395 and 447 kWh/m2a) was mainly a result of older collectors still being in operation, Schmidt explained. Whereas the 37,600 m2 in Dronninglund were installed in 2014, more than half of the 33,000 m2 in Marstal had been installed before 2004, while 15,000 m2 were added in 2012. In Braedstrup, 8,000 m2 of collectors were inaugurated in 2007.

In addition, the Solites researcher analysed the relationship between heat taken from the storage tank and the tank storage capacity, which leads to the number of storage cycles. A ratio of 1 is achieved when – as in the Marstal case – a large part of the heat is fed directly into the district heating network. In Dronninglund, the mode of operation is that almost all solar energy is transferred to the grid through the seasonal storage tank, drawing more than twice the energy capacity of the pit storage over a year. System efficiency also depends on these different modes of operation because it includes the losses compared to heat utilisation by tank.

Braedstrup cannot be directly compared to the two other installations. Its pilot-phase borehole storage offers a much lower heat capacity (400 MWh) and maximum temperature (about 49 °C). Still, the monitored solar share of 23 % is higher than the 18 % that the system was expected to have. An extension of the seasonal storage is in preparation.

More information:
Gram district heating
Institute of Thermodynamics and Thermal Engineering
AEE INTEC
Steinbeis Research Institute Solites

Riccardo Battisti


Participate in the upcoming SDH events
Participate in the upcoming SDH events

See event calender for other upcoming events

NEW Brochure and Project Leaflets
NEW Brochure and Project Leaflets
European Large Scale Solar Heating Plant Database
European Large Scale Solar Heating Plant Database
Download all SDH guidelines in one file
Download all SDH guidelines in one file
Find professionals
Find professionals
Click here to find business partners, component suppliers, consultants and service providers with long term experience on the field of solar district heating!
SDH related projects
SDH related projects

Discover other european RTD and policy projects related to solar district heating:

click here